Hi Roy:
NOT AT ALL! 60/40 content solders are just fine as well. But since 63/37
was readily available, and because it leaves less chance of a cold joint, I
chose to provide info for that type of solder.
All the vendors noted offer 60/40 content solder as well.
By the way, the Multicore link which Joe (W2KJ) just posted to the
reflector is a really GOOD one! Their price is less than HALF of that shown
by the other vendors on the list, and they will sell single-lot rolls. I
just called them to confirm that. I think Elecraft will be adding R.S
Hughes http://rshughes.com/products/mm00979.html to the solder vendor list
soon... at least, that's the impression I get.
73,
Tom Hammond N0SS
At 07:30 AM 9/28/2005, Roy Morris wrote:
Does the recommended list of solders to use mean that 60/40 .032 dia.
(Radio Shack #64-009E) should no longer to be used? Roy Morris W4WFBNo
virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.344 / Virus Database: 267.11.6/111 - Release Date: 9/23/2005
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
