The SB-610 is not a spectrum scope like the SB-620 so you can't get a
panadapter display. I don't know what IF frequency your unit is set up
for but you'd probably have to change the tuned circuit to the 8215 kHz
(sorry "kc" :=) IF of the K3. You likely also will need a preamp since
I believe the SB-610 was designed to connect to the last IF amplifier of
a receiver, not the first IF as in the K3.
Alan N1AL
On 1/17/2013 1:07 PM, Jan Ditzian wrote:
I have a K3-100 with KIO3 and KXV3, an Ameritron AL-82 amplifier, and a
Heath SB-610 RF display scope. The SB-610 is currently able to monitor
the K3 and AL-82 outputs during transmit, displaying either the
sinusoidal output or an RF Trap.
Has anyone used the K3 as an input to the SB-610 on receive? I am
interested in: (1) what the necessary IF setup is for the SB-610 (I may
have the components for the alternatives); (2) whether the KXV3 rear
panel IF output can be used; (3) what the display shows on receive given
the way you have set things up (frequency range).
Thank you,
Jan, KX2A
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
