Sri if it's obvious, but is XIT or RIT enabled? 73, Ron AC7AC
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Martin Sent: Thursday, January 24, 2013 1:11 PM To: elecraft Subject: [Elecraft] [K3] Ref Cal failed Elecrafters, a fellow ham kept telling me i am off frequency, so i performed the CAL REF Method2 per the instruction manual. A 10m ssb qso with him showed that i now am within a few hz to his rx. I then had a qso on 80m with a few SDR-guys. They told me i'm off about 100hz. I trust them. I don't remember anyone complaining about me beeing off freq on 80m before. What did i miss? Any other parameter to check? Method 2 Before the calibration the K3 had a warm-up for at least 2 hours. 10Mhz WWV, CONFIG:REF CAL. S P O T on Matched beat note to sidetone. Accuracy to my ears was less than 1 hz (as a cw op i'm good at this) 73, Martin ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
