Howdy K3' people: I have not solved an annoying bugaboo with the workings of the transverters.
So I unchained the three and am trying to get the 6m transverter to stay consistent. the 432 and the 144 will work individually. The 6m one is not-sp-much For example, I have the 6m internal ability to get on six and I have the red-hot, weak-signal ready, xv50. But when I try to transmit, it may or may not actually put out RF/make the LED;s light and make a sound of some internal relay inside it. Or ... I will put out 30 watts. I was calling cq a little while again. I then dialed around looking for 6m beacons. There seems to be certain combinations of buttons I can activate which will make the transverter not put out RF. Sometimes I can shut the power supplies off and come back later and it will transmit. I have inspected cables; swapped cables; twisted turned and shook, looking for loose connections . I am not able, even at the moment, to make the darned thing transmit. Yes, the XV50 light is on. Just out of curiosity, how t=does the 6m transverter know that if I use DxLab Commander to select 50.095 CW, that I am talking about a transverter and not the internal? Cuz, if I go Band-up to 6m, I am on the internal 50meg band. If I i use 'Commander' then I get activation on the XV50 but not always the output. -- 73 KD7YZ Bob ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
