You might want to try setting the LCD and/or LED levels again, using MENU. If the panel LEDs and LCD backlight both come on when you power up, there isn't anything wrong with the hardware.
73, Matt Zilmer Consultant - Product Management Dept. Magellan Navigation / MiTAC Digital Corp. Tel: (909) 394-6052 Cell: (909) 730-6552 In status quo voluntas non sufficit -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Dale Huffington Sent: Tuesday, February 05, 2013 10:32 AM To: [email protected] Subject: [Elecraft] Info on front panel LEDs Hi - my first message, so please advise if I should address my help request to someone else. I was moving up the bands to look for sounds of activity, and when I hit 18 mHz there was a "pop" from the rear and the panel lights went out. Receive and transmit functions seem ok for CW. I haven't tried sideband yet. I have not found anything in the instruction manual concerning turning the Panel LEDs on or off. The lights come on when the power first comes on, but when boot-up is complete, the lamps go out. I suspect I pushed two buttons inadvertently ("band" and "menu" perhaps? Any suggestions will be much appreciated. 73, Dale, AE0S ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
