Tom,
An INFO 080 message is the result of a failure of the MCU to obtain the
expected response from another microprocessor in the expected time.
Since it does not happen when you disconnect the KAT100, I would suggest
first checking the connecting cable, then the AUXBUS path in the
KAT100. Try reseating the KAT100 firmware IC if you do not find a cable
problem, and if all else fails, replace the KAT100 firmware.
73,
Don W3FPR
On 2/6/2013 8:46 AM, Tom Warren wrote:
On the heels of my XV432 'issue', and totally unrelated because the XV432 is
interfaced to a FlexRadio, my faithful K2/100 is showing an "Info 080" message
on startup.
I've found that by unplugging the DB9 from my KAT100 the rig operates normally.
What is my next step to track down the problem ?
All suggestions welcome ;0)
73
Tom
W4TMW
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
