Hi All
I am new to this list . had my K3/10 sitting on the shelf for the last 6 months as I made the transition from a Flex-5000A VU. I am now scrambling get everything hooked up and running again. I only operate 6m and 2m (plan on using external LT2S Transverter, but I may get the internal unit). Always doing the opposite to the masses. Since I use external amplifiers and preamps, I use sequencers and split RX and TX coaxs. Plan to use ANT1 and RX Ant In for 6m and XVTR IN & OUT for 2m (hopefully this will work). The question is . is there a simple way that I can get a unique TX GND signals for 6m and 2m to drive the sequencers? I read about using Acc Pin 10 Keyout LP for 2m and standard rear Key Out for 6m, but I suspect that Key Out will be active on 6m and 2m? Suggestions? I am guessing that I will have plenty more questions as I try to get everything including LP-Pan 2, Signal Link, and WSJT running to get back on EME quick. Thanks and 73 Kevin VE3KH ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
