P3, no SVGA, FW 1.20
VFO A cursor goes off the edge and the display does not reset to the
next segment. The "Cursor Is That Way" arrow appears. Tuning back into
the displayed segment gets the cursor back.
If, while cursor is off the display, I change bands and then come back,
all is well.
Example:
SPAN=50KHz. VFO A=14.030.000, left edge is 14.000.000, right edge is
14.050.000
Tune up to 14.061.000 VFO A cursor goes off the right edge and arrow
appears. Left and right edges of display are still 14.000.000 and
14.050.000
It is not repeatable. It is not band-dependent. It may be correlated
with how fast I tune past the right edge the first time, but once it
happens, the display range stays fixed and I can move the cursor off the
screen at any tuning speed. I've never observed it off the left edge of
the display.
Not a crisis, just an "anomaly," a term used by NASA to denote anything
from a one-time unexpected noise to the rocket landing pointy-end down
outside of Phoenix.
73,
Fred K6DGW
- Northern California Contest Club
- CU in the 2013 Cal QSO Party 5-6 Oct 2013
- www.cqp.org
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
