Bill,
The transmit/receive information will be sent to N1MM in response to an
IF command issued by N1MM or in response to a TQ command (again issued
by N1MM). The TX.RX state is not included in the AI meta command (see
the K3 prorammer's reference).
You may have to ask the N1MM forum for additional information. I am not
sure what commands are used when N1MM polls the K3/
73,
Don W3FPR
On 2/9/2013 4:36 PM, Bill - W4RM wrote:
I need a little help getting my K3 with footswitch plug into the back of the
K3 "PTT IN" to key the Enter Send Mode (ESM) in N1MM. I'm assuming there
is a way that I can pass the footswitch closure through the K3 radio and
using LP Bridge into N1MM to act as if I hit "Enter" on the keyboard.
So far I have not luck in making it work.
Configuration
K3 on com 3 connected to computer
LP Bridge passing K3 to Comm 6 in N1MM (radio interface working)
CW keying is winkeyer usb on Comm 4 (Working)
N1mm set for ESM and that is working
But I can't figure out the setting to have the PTT from the footswitch in
the back of the radio make it into N1MM to key ESM.
Any help would be great!
Thanks
73 Bill W4RM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
