Effectively you would be asking the K3 to control N1MM Logger's TX/RX
status. I'm quite sure you can't do this - the control goes the other
way (from N1MM Logger to the rig).
The normal way to set this up is to connect the footswitch to the
computer via a serial or parallel port interface, configure N1MM Logger
to use that serial or parallel port for footswitch input, and then set
up some form of PTT control from the Logger to the radio. The simplest
way for N1MM Logger to control PTT on the K3 with your equipment would
be simply to connect a cable between the WKUSB's PTT output and the K3's
PTT IN. N1MM Logger uses the WKUSB's PTT output in all modes, without
requiring any configuration other than that required for CW keying.
73,
Rich VE3KI
W4RM wrote:
I need a little help getting my K3 with footswitch plug into the back of the
K3 "PTT IN" to key the Enter Send Mode (ESM) in N1MM. I'm assuming there
is a way that I can pass the footswitch closure through the K3 radio and
using LP Bridge into N1MM to act as if I hit "Enter" on the keyboard.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
