As further background, I am using the K3/100 remotely via RemoteRig with a K3/0 at my control QTH. I would like to setup the KRC2 at the remote or radio location connected to the K3/100 AUX bus. Then I could use the PF1 and PF2 buttons on the K3/0 to control relays at the remote or radio location. One of the relays will switch the audio lines from the K3/100 that go into the RemoteRig radio box. Normally the two receiver audio lines will be brought back via the Internet but when I activate the relay, the main receiver speaker audio and line level audio will be brought back for RTTY and other sound card applications which need fixed level audio (when doing RTTY it's nice to be able to turn down the volume some). In addition, I want to be able to switch antennas (not based on band) and control other functions as required.
Apparently according to the manuals, the PF keys can be programmed via the K3 Setup Utility but I cannot find the specific command syntax to load into the macros. 73, - Craig, AE6RR -----Original Message----- From: Jack Brindle [mailto:[email protected]] Sent: Monday, February 18, 2013 10:27 PM To: [email protected] Cc: Craig - AE6RR; Elecraft Reflector Subject: Re: [Elecraft] How to program the K3 PF buttons to control a KRC2? The KRC2 ACC outputs are very explicitly available through the K3's ACC menu control. what Craig needs help with is some way to access that control using macros. So the question is how to access that menu setting in the K3. Any ideas? JackB, W6FB Sent from my iPad On Feb 18, 2013, at 7:35 PM, Don Wilhelm <[email protected]> wrote: > Craig, > > What specifically do you want to do? > > The KRC2 does select different outputs according to the band the K3 is on, so the band outputs can operate your antenna selection on the remote switch. The KRC2 configurator program can assist with the "which band(s) selects which KRC2 output". > > Why do you need additional control from the K3? The KRC2 ACC outputs are only accessible from the buttons on the KRC3 itself, and are not accessible through AUXBUS commands as far as I know. > > I do not think the PF1 nor PF2 buttons are capable of issuing any AUXBUS commands. Check the K3 Programmer's Reference for the commands that can be executed with macros. I see none that directly control the AUXBUS. > > 73, > Don W3FPR > > On 2/18/2013 9:24 PM, Craig - AE6RR wrote: >> Help, >> >> I am posting this again. Is there some way to program the PF buttons >> on a >> K3 to control a KRC2 connected to the AUX bus? >> >> >> I would like to be able to use the PF buttons to manually select >> antennas on a remote switch and control other items at my remote >> location with the PF1 and PF2 buttons. > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net Please help support this email > list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
