Wire it as Hot to tip and return and ground to the sleave.
I use the same mic. I find it a little boomy so I cut 50hz to
minimum 100hz to minimum 200 HZ to -6 400 to -3, 800 at 0 and the
rest to +4 except the 3200 hz at -2 Bias off, and High gain
Hope this is what you needed
73
David Moes
[email protected]
VE3DVY
On 3/1/2013 5:16 PM, Benson Wills wrote:
I'm hoping to get my mic wired for the contest tomorrow. I have an XLR mic
(AKG D5) which has:
Pin 1: ground
Pin 2: hot
Pin 3: return
Just got back from RadioShack after waiting in line 15 minutes while the
iPod and cell phone repairs were handled, just to get a 1/8 mono plug.
I've got some CAT5E cable to use, and I also have a standard XLR cable.
Does "hot" go to the center and ground & return go to the outside conductor?
I know that I'll have to select the rear panel mic option in the menu. Are
there other settings, i.e. bias voltage, that have to be set?
73
Benson / NE4W
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
