See the P3 Owner's Manual section "How to Set Up and Interpret the P3
Display" the paragraph that starts, "You would expect the S meter on the
K3 and the signal on the P3 display to indicate the same level..."
Basically, the P3 has an effective receive bandwidth narrower than the
K3. So for a narrow-band signal like CW they should read the same, but
for a spread-out signal like SSB, each frequency point of the P3 only
contains a fraction of the total signal so it appears to read lower.
Alan N1AL
On 3/8/2013 11:18 AM, Paul VanOveren wrote:
Just listening to 9a2na on 15 meters....S-9 on the K3 S meter and about
S5-S6 on the P3 and also on the larger monitor, SVGA...How do I get them to
match each other?, or at least be somewhat similar strength.?
NF8J
Paul VanOveren
5911 Snow Av
Alto, Mi 49302
(616) 868-7149
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
