Hi Bruce, It might suggest that the power supply puts out a lot of RF noise. This would have little impact on IT equipment, but might make it undesirable to use near a radio. I would give it a try and see how it works. But before doing so, I would get out a volt meter and make sure that the output is 12 V without anything else connected to it. If the voltage is OK, then it might work fine for your application. 73 - Mike WA8BXN -------Original Message------- From: K1FFX Date: 3/8/2013 9:39:11 PM To: [email protected] Subject: [Elecraft] [K2] Power supply for KAT100-1 My KAT100-1 kit will be showing up some time next week and I'm looking into a power source for it. It turns out I have just taken offline a Sony LCD display that I've used for several years. The display is powered by a external AC adaptor rated at 12V and 2A. The specs are more than adequate for powering the KAT100-1. However, the adaptor is marked "for use with information technology equipment." So, I'm not sure what it's warning me about. I'd appreciate any advice as to whether this would be an appropriate power supply for the KAT100-1. Thanks - Bruce K1FFX ----- Bruce Rosen K1FFX K2/100 6982 KSB2 -- ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
