Eric,
Make sure you are using 45 bps press and hold for 2 seconds the AFX(DATA
MD) button and adjust VFO A knob. Mark Space is set to 2125 - 170 using
SPOT Button held in for a few seconds. Threshold is not critical mine is
set to 3 and ON by holding in the Text Decode button for a few seconds.
Back off on the RF gain to get rid of the extraneous noise characters and
fine tune at 1 Hz or 10 Hz maximum. You should see the signal start to
decode. I very much like to use the Elecraft Utility Monitor with stored
messages and a good big screen to display plenty of data.
I just worked them on 14.089.92. Good luck.
73 Doug EI2CN
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of eric norris
Sent: 09 March 2013 20:34
To: [email protected]
Subject: [Elecraft] K3 need help with FSK-D
Dear Gang:
I am trying to chase down a last TX5K contact on RTTY and cannot get FSK-D
mode to work on my K3. I followed the steps in the manual, and have been
trying various THR levels in DECODE, but all I get are random letters even
with what looks like a strong signal ( peaking 3 bars on each side). I must
be missing something simple--any ideas?
Thanks,
Eric WD6DBM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
