Hi Arliss, I recently had a similar problem with my K3. I contact Elecraft and received this response from Gary:
--------------------------------------------- See if it will produce 12w on 160-10m, and at least 8w on 6m, in Tune, with the KPA3 menu set to Bypass. The VFO should be near the middle of the band. Check the 3 LPA mounting screws on the bottom panel are all tight too. Be sure it passes VCO MD CAL too, and the ADC REF menu is set as shown below: --------------------------------------------- In my case, running VCO MD CAL cured it. I also asked Gary why this value may have been corrupted - here is his response: "It does change sometimes with age or changes in temp, humidity, or altitude. Not a bad idea to redo VCO MD CAL from time to time." Andy VK4KY -- View this message in context: http://elecraft.365791.n2.nabble.com/K3-power-output-instability-tp7571269p7571271.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html