Mine works the same. Sent from my iPad Chuck, KE9UW (Jack for BMW motorcycles)
On Mar 16, 2013, at 8:17 PM, "Bill Wiehe" <[email protected]> wrote: > > > As a follow up the recent information passed along on the subject under > another thread (* on KPA500) I am looking for some additional clarification. > I was under the impression that > KPA500 would go into standby automatically when the KAT500 went into a tune > mode. > Apparently this is not the case unless I have something set wrong. I have > found > when changing bands if I initiate the K3 “tune cycle” the KPA500 will not go > into > standby.The KPA500 goes in and out of transmit mode and eventually will go > into a "soft fault" if there is an initially high (SWR) while the KAT500 > continues to look for a match. The fault due to high reflected power of > course is as it should be and must be cleared to proceed. Just curious but is > this correct expectation or is there a > set up function I missed that automatically places the KPA500 in standby > when the As I said I was under the impression that whenever > the KAT500 did a tune the KAP500 would go into standby. > This is not a major problem as I have set up the KPA500 now > to go to standby whenever I change bands as well as initial start-up. I am > still curious however if I missed something. > Thanks > > Bill – W0BBI > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
