Sam,
Could I offer a suggestion? Hold the right side of the mode button to
put the K3 into TX TEST to prevent any RF from going out if the K3 is
falsely triggered into transmit.
73,
Don W3FPR
On 3/21/2013 2:45 PM, Sam Morgan wrote:
I run my K3 with 'CW in SSB' enabled
this is found under CONFIG: CW WGHT
Tap 1 to select SSB -CW (default) or SSB +CW (allows CW in SSB modes)
My problem is, while in SSB,
I often use the [VOX-QSK] button to turn the mike/vox off,
because I am trying to prevent any unintended transmissions.
all goes well unless I happen to bump my cw keyer
and then the K3 starts sending a string of dits or dahs :-(
if I also have the audio volume down,
I don't even know I'm transmitting *NOT GOOD*
because with the nice quiet solid state relays
there is no keying kerchunk like I hear when my amp is keyed.
so my request is this
if 'CW in SSB' is set on
and the K3 is in SSB
when the [VOX-QSK] button is pushed to turn the mike/vox off
can you somehow tell the software
to also *not* allow my cw key or keyer
to cause the K3 to transmit the cw tones?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
