Hi Viz: Just a thought
When you reopen the KPAUtil software in step 2, go to the "Port" tab and
Test Communications. When it has set itself up (usually at 38400) and says
things are ok, then go to the "Operate" tab. It should now portray the
actual operating conditions - I have to do this on occasion when things get
out of sync.
Hope this helps.
73, Doug VE3MV
----- Original Message -----
From: "4Z4OQ" <[email protected]>
To: <[email protected]>
Sent: Friday, March 22, 2013 6:22 PM
Subject: [Elecraft] Remote KPA500 Via Moxa - On/Off Switch via S/W not
stable
Hi
My Set up is TS-480 via remote rig and controlling KPA500 & KAT500 via
Moxa
rs232 Server port 1 38400bit/s. My issue is as follows:-
1. I can connect to the Amplifier via KPA500 utility, can change bands,
can
switch from stby to oper but sometimes times cant change the power switch
to
off mode.
2. In amplifier is on stby (ON) mode and by mistake close the utility SW,
when I reopen the software the o/off status is off, but I know the
amplifier
is On
Any ideas..?
--
View this message in context:
http://elecraft.365791.n2.nabble.com/Remote-KPA500-Via-Moxa-On-Off-Switch-via-S-W-not-stable-tp7571721.html
Sent from the Elecraft mailing list archive at Nabble.com.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
