I have installed the 100w amp in my K2 and am in the final calibration
stage but I have encountered a problem. When switching in the amp
stage, I get a "Hi Refl" message. This is problematic because I am
transmitting into a 50 ohm commercial dummy load, and I have tried 3
different coax jumpers with no effect.
Is there a setting for the SWR sensor that I am missing? Is there a
component or connection that I should check?
Thanks in advance
Dana N6DW
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
