Any capacity NiMH cells are OK. They will charge at the rate of 200 mA. Your 1900's should charge from 0SOC to fully charged in about ten hours.
Don't forget to enable the KXBC3. Try setting it to 12 hours. 73, matt W6NIA On Sat, 06 Apr 2013 13:01:43 -0400, you wrote: >I noticed that my Powerex 2400 mah batteries do not seem to be charging >in the KX3. I took them >out and put them on a dedicated charger. I'm sure they are fine. > >I just installed Sanyo 1900 mah batteries to see there is a difference. >I won't know for awhile. > >So here's my question: Is 2400 mah capacity too high for the KX3 >charger? If not and >the 1900 mah don't charge either I will have isolated the problem. If >so, are the >1900 mah capacity OK? > >All batteries are less then 2 years old and lightly used. > >73, Dick, WN3R >______________________________________________________________ >Elecraft mailing list >Home: http://mailman.qth.net/mailman/listinfo/elecraft >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:[email protected] > >This list hosted by: http://www.qsl.net >Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
