Hello all.
Yesterday I noticed a tx fault on my K2 in LSB. When set to 15W, between pauses
in speech, the RF rose to 5W and made sort of grinding noises when heard on a
receiver. Talking reduced it, but in speech pauses it built up again over a
couple of seconds.
SSBA set to 1 and SSBC 2-1, although changing these settings didn't seem to
make any difference.
I switched to a dummy load which made no difference either, so not RF feedback
I don't think. There was also what sounded like a one-second tick in the
'modulation' - from the real time clock perhaps?
Selected BAL on the menu, and re-adjusted R1 on the SSB board, but the erratic
levels of RF (looking on a scope across 50 ohms) didn't really dip.
Switched to USB, and all ok! Got a nice dip on R1. Back to LSB, and all ok now!!
Anyone any ideas what was going on? Just used it on air and it's all fine again.
BTW, the earlier fault where I couldn't get anything out on SSB, and
occasionally mic-through-speaker feedback was me just leaving the K2 in in BAL
mode by accident!
Thanks,
Ian, G4JQT
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
