Vince,
There is an adjustment - it is the alignment for the SSB FL1 filter - it
must be the OP1 filter, and the low frequency -3dB 'corner' of the
passband should be set close to 300 Hz. I suggest using Spectrogram so
you can see the passband visually. See the instructions in Part 3 of
the article on K2 Dial Calibration on my website www.w3fpr.com.
Do check the BFO range as well (before adjusting the filters) to make
certain it has not shifted while the K2 was not used. If it has
shifted, an unsoldered connection is the most likely problem.
73,
Don W3FPR
On 4/24/2013 8:30 AM, Vince Santis wrote:
I haven't used my Kw for some time and fired it up yesterday. H had
reports of high in my signal to the point of not being recognized by
people I talk to to routinely.
I've searched the manual and find no adjustment for the problem. Any help
out there?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
