Christophe, What you observe is normal if your sidetone pitch setting is 700 Hz.
When using CW mode, the K2 transmit frequency will be offset from the receive frequency by the amount of the sidetone pitch setting you have in the menu. If you are in CW normal, transmit will be lower, in CW reverse, it will be higher.
There is no offset for SSB or RTTY modes - the transmitted carrier (suppressed) frequency will be the same as the receive carrier frequency.
If you need assistance calibrating the K2 dial frequency, read the K2 Dial Calibration article on my website www.w3fpr.com.
73, Don W3FPR On 4/30/2013 8:38 AM, Christophe F8ACF-56 wrote:
Hello list, I want to know if I have a problem with my K2? listening to the tag "DK0WCY" it is on 10.144, off if I listen with the display of 10,144 in "CW" is OK, if I put the filter "CW FL1" I have to flunk my reception lower than 700 hz so: 10.143.3 MHz normal? I stalled the display as described in the manual listening WWW 10 mhz, the whole procedure is well spend. I hear both the beacon on 14.100 in "CW" and even if I put the problem FL1 and other K2 is OK to transmission anything I already reported some contacts what fun! I still KAF2 under construction and KNB2, KSB2, KPA100 build thank you for your help
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
