Well not quite everyone. As a subreceiver owner I love the concept and would
suggest that this feature be available for all. I can see it being there when
the subreceiver is not in use.. That could another option to select.
Admittedly I have no clue as to how much programming effort we are asking for
and also at some point there will be hardware limitations too. The program and
setting storage space is not infinite.
The use of the subreceiver in my case is pretty limited to split usage while
chasing DX. It can be seen on the P3 so maybe even a "Marco" to turn it on or
off could be used too.
73,
Bob
K2TK ex KN2TKR (1956) & K2TKR .
On 5/6/2013 1:40 AM, Gary Gregory wrote:
I would rather see a lot more options to display in VFO B...everyone would
be happy then...:-)
73
On 6 May 2013 15:06, Bill Frantz <[email protected]> wrote:
I'd rather have the DSP filter information. High and low cutoff or center
frequency and bandwidth depending on which mode is set for the controls.
YMMV - Bill, AE6JV
On 5/6/13 at 9:55 PM, [email protected] (Val) wrote:
I wish we had there the CW speed too. There is a place for both values.
73, Val LZ1VB
Can the K3 Sub Receiver display (without the 2nd receiver installed) be
programmed to show the power setting as a selectable continuous display as
opposed to the power setting flashing when the PWR knob is turned?
...
Allen Griffith N5AG K3 #03547
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
