Make sure the HP's output signal level is about right (~12.5 dBm, I think...) before using it. If it's a square wave output at 5V/0V, you're supposed to add a series resistor. I think this is all in the K3EXREF manual.
73, Matt W6NIA -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of W4CCS Sent: Tuesday, May 07, 2013 2:05 PM To: 'Matt Zilmer' Cc: [email protected] Subject: Re: [Elecraft] GPD 10 MHZ Reference Thanks to all who replied.. I just had a friend of mine give me an HP 58503A. Think I'm going to give it a try.. W4CCS >What are you using as a 10 MHz source for the K3EXREF..?? > > > >Clyde scott - W4CCS > > > >______________________________________________________________ >Elecraft mailing list >Home: http://mailman.qth.net/mailman/listinfo/elecraft >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:[email protected] > >This list hosted by: http://www.qsl.net Please help support this email >list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
