Good evening to all, yes it is that it is written in pencil "3.6" on the back of the envelope
thank you again for your help 73 , Christophe F8ACF-56 ________________________________ De : Don Wilhelm <[email protected]> À : Christophe F8ACF-56 <[email protected]> Cc : "[email protected]" <[email protected]> Envoyé le : Mardi 7 mai 2013 22h43 Objet : Re: [Elecraft] K2 - KSB2 Christophe, Look on the other side of that crystal envelope. You should find a number penned in by hand. That is the number you need. It is the nearest 100 Hz increment that the crystals were matched to. The crystals are actually matched closer than that (I recall matched to 10 Hz), but that number is sufficient for setting the filter properly later in the alignment procedure. 73, Don W3FPR On 5/7/2013 4:04 PM, Christophe F8ACF-56 wrote: > Hello list, > > in manufacturing manual it says: > > Locate the envelope containing the matched SSB filter crystals (X1-X7). On > the outside of the > envelope you'll find a calibration number that ranges between 3.2and 3.9. > Record the number: ______. > Note: If the envelope is unmarked, use 3.6 > > in the accompanying photo, you have the crystal frequency and envelope > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
