That sounds like a P3 cable problem. There have been reports of faulty BNC cables supplied in a batch that was bad from the supplier.
Try contacting Elecraft and describe the problem to them. Also while you are waiting to call Elecraft over the week-end, make sure that ALL of the cable routing is as it was before the installation. That covers any existing cables you may have moved around. Good luck, 73, Tom Amateur Radio Operator N5GE ARRL Lifetime Member QCWA Lifetime Member On Sat, 18 May 2013 18:41:53 +0200, "Fausto Coletti" <[email protected]> wrote: >Today I installed the module K144XV. It all works ok but I noticed several >spurious signals received, in particular each 12.5 kHz at a level >of around -140 dbm indicated on P3, plus some pretty strong signals such as at >144.4165 to S7 and others. >Obviously signals are present with the antenna disconnected and with a 50 Ohm >load on the antenna connector. >I exclude the origin from the outside of the transceiver, I disconnected all >possible noise sources such as switching power supplies and similar. >It 's normal or there may be a problem? Any suggestions? > >Fausto IK4NMF >______________________________________________________________ >Elecraft mailing list >Home: http://mailman.qth.net/mailman/listinfo/elecraft >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:[email protected] > >This list hosted by: http://www.qsl.net >Please help support this email list: http://www.qsl.net/donate.html 73, Tom Amateur Radio Operator N5GE ARRL Lifetime Member QCWA Lifetime Member ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
