If you go this route, as I did, don't think that the two pin jumper should span the two Header #5 pins!
Doing so reduced the initial turn-on display from "ELECRAFT" to "ELE" and locked the rig. Instead, put the jumper ONLY on the #5 pin nearest the mic jack, leaving one jumper slot hanging in space. I had thought that spanning the two #5 pins might put a small, insignificant bias on the audio out line. Not the case! Chris NQ8Z -- View this message in context: http://elecraft.365791.n2.nabble.com/Connector-for-K2-Mic-Config-header-tp7573939p7574708.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
