You can do a "Parameter Initialization" as described in the
Troubleshooting section of the manual. Basically, you hold the LABELS
key while turning on the P3 with the POWER switch. Wait until the
"CONFIGURATION RESET" message appears on the screen and release then
release the LABELS key. If you have the power-on jumper in the P3
configured to always-on, then just hold LABELS and tap POWER.
Alan N1AL
On 6/8/2013 8:07 PM, Gary Gregory wrote:
Things have been going well until 'Fat Fingers' decided to press buttons.
Is there an easy way to set the P3 to default settings other than sing the
utility?
Busy in a contest and would like to not have to disconnect the logging from
the K3 to fire up the utility.
73
Gary
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
