Thanks, Arie. I found the problem. the TMP connector on the cable
running from J5 on the KREF3 board to J82 on the KRX3 had worked loose
at the J5 end, where I couldn't see it until I removed the sub-RX again
and the cable came away with it. All is well.
73, Pete N4ZR
Check out the Reverse Beacon Network at
http://reversebeacon.net,
blog at reversebeacon.blogspot.com.
For spots, please go to your favorite
ARC V6 or VE7CC DX cluster node.
On 6/10/2013 7:21 AM, Arie Kleingeld PA3A wrote:
Pete,
If all tmp cables are fitted right and the menu settings are OK, how
about the bottom-connectors to the K3 main-board?
73
Arie PA3A
Op 10-6-2013 13:08, Pete Smith N4ZR schreef:
I've checked and rechecked the crystal filter setup, the TMP cables,
etc. Before I tear it open again, is there anywhere in particular I
should be looking?
73, Pete N4ZR
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
