Actually, the K2 has a built-in alarm that can be used to indicate a low
battery voltage.
It is the CAL CUR menu setting. Its use for that purpose is a little
bit 'convoluted' because it depends on the way the K2 power control
operates to keep the requested power level no matter what the voltage
may be.
To set it before your battery operation, connect the K2 to an 11 volt
power source (assuming you want the alarm to trigger when the battery is
11 volts or less), then tap the DISPLAY button and transmit with the
power set to your desired level -- observe the current.
Now set CAL CUR to that value. When you begin to see HiCur messages, it
is time to change the battery.
After your portable battery powered event, restore the CAL CUR menu
setting to the normal 3.50 setting.
Yes, I know the normal base K2 manual says 2.50 for CAL CUR, but with
the KDSP2 installed and some other options, HiCur messages can be
produced with the power control set fully to the max. I do not
recommend that power be set higher than 10 watts, but some operators
insist on squeezing every bit out of it, then object to the HiCur
messages. Do not go higher than 3.50 on the CAL CUR menu setting.
73,
Don W3FPR
.
On 6/14/2013 7:21 PM, Ariel Jacala wrote:
Bruce is right. QST had an article last month for a programmable LED to
monitor battery voltage. It is easy to make. You should monitor the resting
voltage to provide some margin from over discharging
Ariel NY4G
Sent from my iPhone
On Jun 14, 2013, at 7:17 PM, "Bruce Beford" <[email protected]>
wrote:
Is this more or less accurate, or have I missed something? Thanks.
You missed the fact that you really can't/shouldn't try to discharge the
full capacity of the battery. The life span of SLA batteries for instance,
are greatly reduced if you routinely go to greater than 50% depth of
discharge.
73
bruce
N1RX
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
