This has happened to me on couple of occasions while puttering around in back of
my radio bench. The Anderson
Power-Poles are convenient but have virtually no retention. If this happens, you
must use the "Parameter Initialization"
routine on page 63 of the manual. NOTE: This will NOT work if you have the
RS-232 cable connected!!!
Then reload all your configuration settings using the K3 Utility program. You
DID save the settings, didn't you?
73, Roger
On 6/15/2013 8:49 PM, Jim Wiley wrote:
My apologies if this has been asked before.
When reading various posts concerning the operation of the K3 transceiver, I
get the impression that if the radio is powered off by simply removing the 12
volt source, as opposed to using the K3 front panel switch, there is the
possibility of scrambling the memory that manages the configuration of the
set. Is this true?
If not, then no problem.
But, if this is true, are there any plans to implement some sort of memory
protection scheme, such as including a memory "keep alive" system powered from
an internal or external source? Your comments please.
- Jim, KL7CC
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
--
Remember the Liberty (AGTR-5)
http://www.usslibertyveterans.org/
http://www.gtr5.com/
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
