Gary, anything shared with you? On Jun 10, 2013, at 1:44 PM, Gary Gregory <[email protected]> wrote:
> I understand the sensor port is for an inline sensor to allow the P3 to > monitor the TX signal from the K3. A long time waiting for the release of > this has not dampened my enthusiasm but the lack of information on timing > of the release is disappointing. > > I think i read it is on 'someones' list but that is all I have read. > > Perhaps somebody "in the know" will chime in here? > > 73 > > Gary > > On 10 June 2013 00:43, Rob Gault <[email protected]> wrote: > >> Anything in development to fill the sensor port hole on the P3? >> >> 73 >> kc2vmp >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html > > > > -- > *Gary - VK1ZZ > Skype: Gary.VK1ZZ > Motorhome Portable > The Shack* > *Elecraft K3 > P3 Panadapter > KPA500FT > KAT500FT** > KX3-K > * > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
