Denis,
From that information, all I can say with certainty is that the problem
is somewhere inside the enclosure :-) .
My first guess is that one or more of the connectors on the option
modules has developed a bit of oxidation during its period of non-use.
I would remove and re-insert all the option modules. If you have the
KAF2 or KDSP2, I would start with that because it is directly in the
audio path, then proceed to the KSB2, then the KNB2, then K60XV if
installed and lastly the K160RX.
If that does not help, please give a more complete description of what
you hear on RX - for example, do you hear receiver noise if you turn the
AF gain up? Does the noise level change with the preamp and attenuator
in and out?
73,
Don W3FPR
On 6/27/2013 3:45 PM, [email protected] wrote:
Hi Folks,
My K2/10 hasn't been used for a few months. It was working fine last time
I used it. I turned it on a few days ago with the intention of taking it
out portable and it's developed a problem. The display and all the
controls seem to do what they usually do, in that frequency changes,
antennas switch, volume goes up and down, bands and modes change etc. but
it will neither transmit or receive.
I would be very greatful if someone could give me a heads up on where to
look first! I built this quite a few years ago and my memory of it's
"internals" has faded considerably.
Many thanks and best wishes from Wales.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
