Don,
The manual says (on page 25 of rev C):
"The remaining four drivers, labeled A, B, C and D, are TTL-compatible
inputs or outputs depending on the operating mode. In normal KRC2 or
analog modes, the terminals are outputs. In digital parallel input
mode, they become inputs, and receive the BCD-encoded band data."
It doesn't specify that the output format is BCD, but I can't imagine
what else it would be...
73,
~iain / N6ML
On Mon, Jul 1, 2013 at 5:24 AM, Don Wilhelm <[email protected]> wrote:
> Joerg,
>
> The KRC2 can be configured to accept BCD data as input, but I see no
> reference that it provides BCD output.
>
> 73,
> Don W3FPR
>
>
> On 7/1/2013 8:05 AM, Jörg Rüschenschmidt wrote:
>>
>> Hi all,
>>
>> I have two devices which requires band data.
>>
>>
>> 1.) Bandpass filter with 12 volt input lines per band
>>
>> 2.) Antenna switch which requires a BCD coded input for automatic
>> switching
>>
>>
>> My intention is to use KRC2 in serial mode. I understood from
>> documentation
>> BCD coded band data information will be available on J4 in serial mode.
>> However I am not sure about this topic. My main interest is, could I use
>> one KRC2 to support both devices at the same time ?
>>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[email protected]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
