Don, Scott - et all -
Thanks for the help - after doing a full reset & re-
alignment then disassembling the radio to check
for GND @ mic socket pins 7&8 (ok), I re-assembled
K2 #4913 and focused on the mic again.
I had ASSumed the mic was OK because it worked
FB in my Alinco 2m/440 mobile. Well......
After checking the mic again, I found the ground
braid was bad. I cut 2" off the plug end of the cord
and re-wired the plug. Works!
I looked for a fault in the old cord end and found the
braid was tattered & broken right where the clamp was.
Thanks again for the help!
73 de Ken KGØWX - Flying Pigs #-1055
Elecraft K2 #4913 - Kadiddlehoppers #11,808
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
