I have noticed since the last update of software I am getting more retuning
also.
I had been running a test version prior to that and it did not exhibit the
same retune as often. In fact I did a tune or train check prior to the
contest yesterday by going thru the bands and pressing tune to make sure
everything was good so I could go and point and shoot. However, the
tripping of the retuning process was a distraction.
I do switch antennas a lot as I have 4 choices to pick. I do understand
that the KAT500 only has 3 inputs and am aware if I do the switch for the
4th antenna.
If I were to describe the problem I think that something is getting lost in
the memories. Maybe if the Q of the antenna is narrow maybe the bins for
memory are too broad?
~73
Don
KD8NNU
-.- -.. ---.. -. -. ..-
-----Original Message-----
From: Don Wilhelm
Sent: Sunday, July 14, 2013 9:56 AM
To: KD7YZ Bob
Cc: 'K3 List'
Subject: Re: [Elecraft] KAT500: Tuning on 6m
Bob,
Did you QSY after tuning? If so that would explain what is happening -
you may have moved out of the band segment that you used for the TUNE.
See the lower half of page 9 in the KAT500 manual.
You may want to 'train' your KAT500 on all segments of the 6 meter band.
If you have done that already, you may need to contact support.
73,
Don W3FPR
On 7/14/2013 7:43 AM, KD7YZ Bob wrote:
Howdy K3' people:
There is an 8-element yagi connected to the KAT500 for the K3 internal
6m selected 6m antenna.
I set KAT500 default antenna for 6m to Ant2.
On the KAT500 I can press 'TUNE' then tap K3 "XMIT" and the KAT500 will
usually settle on or about 1.1:1 .
Then when I .run a WSJT, Data, QSO, if the KAT500 is left in "AUTO",
re-tuning will often take occupy 10 or more seconds of the time before
the KAT500 finds a place it likes. Often the SWR is then in the RED or
worse, FAULT. Not very often on FAULT however.
Mostly what I see are SWR's around 2:1 . (KAT500 in AUTO .
If I put KAT500 in BYP, the K3 often shows SWR's of 2 to 3.
If left in AUTO, the mismatch is apparent in received audio.
Without the KAT500, the antenna itself exhibits a 1.3 SWR consistently .
The constant re-tuning or irregular attenuation due to mismatch form
KAT500 is annoying. On a weak-signal QSOit means the difference from
making the QSO or not decoding.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
