Hi Richard, If it really is 12 V, the voltage might be too low. I don't have the manual for the charger at hand in the moment, but I think it says it would like to see 13.8(?) V or something very close to this.
Vy 73 Ralf, DL6OAP Am 31.07.2013 um 14:37 schrieb Richard Neese <[email protected]>: > is there a way to add a option under the firmware to show what the current > batt charge status is ? > so you know if you need to charge or not. > > also I have a 12v 4.58 amp power supply I am using and I get a lower supply > warning when I try to > charge the batt with the radio in standby mode .... > > should 4.58 amp 12v not be enough to charge ? I use the supply to run the > radio and get no issue > sexecpt when I put it in batt charge mode... > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
