Hi!
I have a K3 station with K3, P3, KPA500 and KAT500 connected with the
correct Elecraft-supplied serial cables. The station works great, band
changes are rippled through all components correctly and I have no
operational issues. The PC is 64-bit Win7SP1.
I am however having a problem using both the KAT Utility Revision
1.13.5.12, and KPA Utility Version 1.13.29. Although both stop port
polling at the correct port and speed (COM8, 38000 bit/s), no MCU rev
window pops up as it does with the K3 or P3 Utilities, and no further
action is possible with either utility. I just verified that this setup
works correctly with the P3 Utility to UL the new P3 firmware and with
the K3 Utility, and then made no other changes afterward.
I tried a full power-down and PC reboot, trying the KPA powered on
first, etc., no joy.
Any ideas?
Thanks!
Howard Hoyt - WA4PSC
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
