While transmitting some JT9 at 100w on 6m yesterday and watching the voltage display on the K3 menu I occasionally saw a HI CUR message which then disappeared after less than a second.
I've never seen this before. I was monitoring the voltage after putting in some new cabling from the PS and it has made the supply voltage more stable. The K3 now reads no less than 12.5v while transmitting 100w. Not sure where to start or just to forget about it until it shows a persistent fault. SWR is low and feedlines are 7/8" hardline so I don't think there's a fault in those. If there was I'm sure it would be more evident with the KPA500 at full tilt but there's no such indication. I do have the KPA3 replacement pins kit which I've not yet installed. Is this fault associated with those pin issues? Thanks Jim ab3cv ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
