All,
Apologize if this question has been asked before.
When handling pileups, I've always used the following setup and it truly works
FB - run split, lock the TX frequency, and use the main VFO to listen up/down
for stations.
Over the weekend I installed a RX only loop antenna(Pixel Technologies
RF-Pro1B), and connected it the Aux RX input. I then enabled diversity mode,
linking both main and sub receiver VFO(s). The sub-receiver was setup to use
the Aux RX input, and the main's RX & TX used Ant#1 ( the vertical). Needless
to say, I was extremely impressed with the outcome, and my ability to pull out
the weak signals on the low bands. Diversity mode even helped strong signals
compensate for QSB.
I was so impressed, that it got me thinking if I could run a pileup utilizing
diversity mode in an effort to maximize the capabilities of both antenna's.
My question is, will the K3 allow me to do the following, at the same time?
1) run split
2) run in diversity mode
3) lock the TX frequency
4) use the main tuning knob to change my RX frequency
5) Automatically have the sub-receiver follow adjustments made to the main RX
settings (i.e. VFO, filter, filter BW, PB, NR, NB)?
In a pileup I can't see going into BSET to change individual sub receiver
settings to match the changes being made to the main receiver settings. Tapping
A->B twice, each time I change/adjust settings of the main receiver, might get
a bit tedious.
Thanks in advance,
-rob N7QT
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
