Ed,
Change 2 capacitors on the KSB2 board. C34 to 0.47 uF and C32 to
something in the 3300 pF to 5000 pF range.
I usually run SSBC at 3-1 and SSBA at 1 with the Elecraft MH2 microphone
and it sounds good with those changes made.
73,
Don W3FPR
On 8/12/2013 6:18 PM, Eddy wrote:
K2 serial number 3600+ using the Heil hand mic that Elecraft sells, also did
the KI6WX wide-band mod years ago. When on LSB using the elecraft recommended
settings of SSBA of 2-1 and SSBC of 2-1, I get lousy reports that there's too
much base in my audio and hams find it hard to hear what I'm saying, but when I
turn off compression I then get really good audio reports!
So, for the K2 wizards out there, as long as I leave the compressor off, my
hams friends are happy.......so, I'm wondering why turning on compression
increases the base response and if there's a way to improve audio when using
SSBC 2-1? I've used Spectrogram to slightly adjust audio filter bandpass but
doesn't do much.
As always, thanks for everyone's help!
73......ed
k6sdw
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
