Mike,
I suspect that the 80 meter receive problem has nothing to do with the
12 volt power trace incident.
Do you have the K160RX option installed? If so, check the menu to see
if the RX ANT is ON for 80 meters. That is a per band setting.
73,
Don W3FPR
On 8/18/2013 7:31 PM, Mike Murray wrote:
Recently, while reassembling my K2-100 (#2652) after installing a Clifton
Labs IF out module, I managed to pinch the 12V aux wire that connects the
100 watt module to the main board against the right side panel. After the
smoke cleared, I found a lifted trace on the amp board that feeds the 12V
to the connecting wire. The trace was still in place, but I decided to
remove it and hard wire around just to be certain it would be OK.
Everything seems to be functionally restored except receive on 80M, which
is basically dead.
Anyone have any thoughts on where to start troubleshooting?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
