Bill Allen wrote:
If I decide to drive an external amp with my K2, do I need to disable the
ATU?
It's not a good idea to try to operate the tuner when driving an amp,
although sometimes it's useful if you are careful. Probably the best
thing to do is to tune the K2 into a dummy load and activate the tuner.
This will set the tuner up for a 50-ohm load. Then connect the amp
and do not activate the tuner. Most amps should provide an SWR of 1.5:1
or less.
--
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
