Once again, I wonder if I'm being clear. THE TEXT ON THE P3 SVGA IS NOT
THE SAME AS ON THE K3. I'm not sure what the issue is.
On Tue, 27 Aug 2013, Mike K2MK wrote:
Hi Hisashi,
The P3/SVGA board is acting as a terminal. It does not do any decoding. It
just displays the decoding done by the K3. If you're missing characters you
may want to adjust the threshold on the K3. See the decode tips in the K3
manual on page 33.
73,
Mike K2MK
Hisashi T Fujinaka wrote
I was copying RTTY on my P3 SVGA and I found that it was dropping a lot
of characters. I finally figured out how to decode directly on the K3
and it wasn't dropping characters at all.
Is there something I have set up incorrectly?
Thanks.
Hisashi T Fujinaka
--
View this message in context:
http://elecraft.365791.n2.nabble.com/P3-SVGA-RTTY-decode-question-tp7578289p7578292.html
Sent from the Elecraft mailing list archive at Nabble.com.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
--
Hisashi T Fujinaka - [email protected]
BSEE(6/86) + BSChem(3/95) + BAEnglish(8/95) + MSCS(8/03) + $2.50 = latte
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
