I have suddenly started to get an intermittent ERR DSE message on my K3 - the main display shows E0401E2. It occurs about once a day on average I guess. I have reloaded the DSP firmware as recommended but it has not cured this problem.
I recently added a P3 with P3SVGA - it is all working fine. The power for the P3 is not taken from the K3. However the error has only started since the P3 was added, so I suspect something to do with this. The obvious change to the K3 is a change from 9,600 Bd to 38,400 for the P3. The PC, SteppIR controller and SPE 1K-FA all run at 9,600 and connect to the P3 PC connector. It all seems ok. Has anyone else seen this? I would appreciate any help. However I will not be able to try any fixes for a couple of weeks as I am away, but will be watching the reflector for any suggestions. 73 Phil Holliday ZL3PAH ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
