Hi,
I am in the process of installing the KAT2 and need some clarification
on the bridge null adjustment procedure. Following the instructions, I
set the slot of C55 parallel to the K2 rear panel. After activating
TUNE I can adjust it down to about 002 or so. Then if I put it back
into receive, then activate TUNE again, it goes back up to about 030.
Is this normal? Also, on pin 1 of U4, I am seeing about 2.7 to 2.8
volts. Is this close enough to the 3 - 4 volts specified in the manual?
Thanks,
Mike - KI0HA
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
