When you ask to be contacted off-list about a question posted to the list, no
one knows whether you got an answer or not.
So here's my answer: You need to download and install LP-Bridge.
http://www.telepostinc.com/LPB.html
Create a virtual port in LP-Bridge and configure SDR-IQ/SpectraVue by selecting
the K3 In the ExtRadio tab and the virtual port that you created in LP-Bridge.
Make sure the baud rates match and check, the Keep Same Center Freq box.
You can create other virtual ports that connect to logging programs, etc that
need freq/band data from the K3.
Wes
On 8/31/2013 4:04 PM, l s wrote:
Just acquired a rf space sdr- iq receiver and I would like to contact someone
using the same set up.
I managed to make it work as a stand alone receiver with Spectravue and
sdr-radio.com v 1.5 but
I can't get either of the software programs to control the K3. I have checked
the rs 232 cable and the pin out is correct.
This cable works fine with lp pan and powersdr-if. Any help would be
appreciated. Please contact me off the reflector
at- lgs42...@yahoo.com
Tnx & 73
Lou KI6UM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
