Gang, I just upgraded my K3/100 with the KXV3, K144XV, and FM filter. Everything has the latest firmware. Here's the rub. My XV222 works FB when connected to my normal IF radio (FT817) running 0.5W. When I reset the jumpers for full K3 mW interacing and separate RF in/out and control via a newly made interface cable, I get no power out indicated on the 222. Switching sounds good and the trasverter turns on/off with the K3. I've checked the jumpers in XV222, continuity on my interface cable looking for a short, run through the menus on the K3 looking for anything odd. The K3 is putting out 1mW per the display.
I've obviously overlooked something very basic. The 2M module works FB and the transverter works FB when in non-Elecraft radio mode. I have 2M on TRN1 and 222 on TRN2. Ideas? Anything? 73, Mark K2QO K3 #7470 FN03ra ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
